|
Lord Steve
|
 |
« on: August 02, 2011, 10:04:38 pm » |
|
Bit off topic I know but I've just acquired a 3.9 Rover V8 which is about to be mated to an engine stand in my garage for a full rebuild.
The fridge has been installed in the garage as a matter of priority of course, in anticipation of long, thirst inducing evenings.
I'm handy enough with a socket set and a parts washer having rebuilt a couple of Pinto's but can anyone recommend a decent source of reference for the Rover engine?
Thanks in advance
|
|
|
|
|
Logged
|
I tested negative for patience.
|
|
|
|
Lorry
|
|
« Reply #1 on: August 02, 2011, 10:40:35 pm » |
|
The Haynes manual - "Tuning V8 Rovers" isn't a bad place to start, and the RPI engineering site is well worth a look.
|
|
|
|
|
Logged
|
GENTLEMEN - Start your livers
For and on behalf of the Kent Kronenberg Owners Club
|
|
|
|
nopanic - neil
|
|
« Reply #2 on: August 03, 2011, 12:54:48 am » |
|
|
|
|
|
|
Logged
|
If you're going through hell, keep going.
|
|
|
|
Lord Steve
|
|
« Reply #3 on: August 03, 2011, 06:51:58 am » |
|
Cheers guys.
|
|
|
|
|
Logged
|
I tested negative for patience.
|
|
|
|
Snoring Rhino
|
|
« Reply #4 on: August 03, 2011, 07:59:40 am » |
|
Also the basis of V8 TVR engines.
|
|
|
|
|
Logged
|
|
|
|
|
Steve Pyro
|
|
« Reply #5 on: August 03, 2011, 11:06:36 am » |
|
Steve, if it's parts and advice you're after, this guy is a goldmine. http://www.jrv8.co.uk/Really helpful and won't push you into buying parts and 'upgrades' that you don't need. |
|
|
|
|
Logged
|
Steve  East Anglian cobras 
|
|
|
|
Mr Termite
|
|
« Reply #6 on: August 03, 2011, 12:13:48 pm » |
|
Having had a Rover V8 Landie, I have one piece of advice - do not skimp on the oil-pump. Ours clapped out at about 50k miles, cost us a fortune to rebuild the engine. Talking to a pub-friend in the trade he knew of similar cases on this engine.
|
|
|
|
|
Logged
|
Missing Termietermite
|
|
|
|
termietermite
|
|
« Reply #7 on: August 03, 2011, 01:51:28 pm » |
|
Having had a Rover V8 Landie, I have one piece of advice - do not skimp on the oil-pump. Ours clapped out at about 50k miles, cost us a fortune to rebuild the engine. Talking to a pub-friend in the trade he knew of similar cases on this engine.
One of the best tow vehicles on planet Earth though.  |
|
|
|
|
Logged
|
"I couldn't sleep very well last night. Some noisy buggers going around in automobiles kept me awake." Ken Miles
|
|
|
|
Lazy B'stard
|
|
« Reply #8 on: August 03, 2011, 02:23:51 pm » |
|
Don't scrimp on camshaft and followers either. There are some really cheap ones kicking about at the moment that will have no lobes left after 5000 miles. The hydraulic tappets disguise the wear and the first thing you know is that you have an uncurable misfire; the valve ends up almost fully closed which starves the cylinder to such an extent that it won't fire anymore.
We had this problem a few years back on a Range Rover that had been rebuilt just six months before. The cam was shocking.
Si
|
|
|
|
|
Logged
|
Dick Dasterdly was right
'Don't just stand there, do something!'
|
|
|
|
Andy Zarse
|
|
« Reply #9 on: August 04, 2011, 11:47:07 pm » |
|
Steve, if it's parts and advice you're after, this guy is a goldmine. http://www.jrv8.co.uk/Really helpful and won't push you into buying parts and 'upgrades' that you don't need. Lord Steve, listen to Steve Pyro. Wheras I am Mr Monster Munch, he is CA's own Mr V8. |
|
|
|
|
Logged
|
I wouldn't sit there if I were you, it's still a bit wet.
|
|
|
|
Steve Pyro
|
|
« Reply #10 on: August 05, 2011, 09:50:59 am » |
|
Steve, if it's parts and advice you're after, this guy is a goldmine. http://www.jrv8.co.uk/Really helpful and won't push you into buying parts and 'upgrades' that you don't need. Lord Steve, listen to Steve Pyro. Wheras I am Mr Monster Munch, he is CA's own Mr V8. muchas gracias |
|
|
|
|
Logged
|
Steve East Anglian cobras
|
|
|
Truck
CA Veteran
Full Member
 Offline
Posts: 166
Are you HGV positive?
|
|
« Reply #11 on: August 05, 2011, 02:50:30 pm » |
|
Have you seen the DVD of a "Landrover is reborn"
What about the gearbox? SD1 boxes are like hen's teeth, and tend to break anyway. I hear that TR8 rally gear sets aren't much of an improvement either.
|
|
|
|
|
Logged
|
Help, get me out of here. Its Lorry
For and on behalf of the Kent Kronenberg Owners Club
|
|
|
|
Steve Pyro
|
|
« Reply #12 on: August 05, 2011, 05:54:21 pm » |
|
Later RV8 engined cars used the R380 gearbox and a T5 can be easily fitted. Both are adequate for a 3.9s power levels.
|
|
|
|
|
Logged
|
Steve East Anglian cobras
|
|
|
|
Lord Steve
|
|
« Reply #13 on: August 05, 2011, 07:12:52 pm » |
|
Thanks for all the advice gents. I've no particular plans for the beast at the moment - just want to bring it back to an "as new" condition then either sell it or, dare I say, persuade she who must be obeyed to let me drop it into a Cobra rep.
Steve, I'll have a look at that link in a minute and you may start to see the odd pm coming your way as I proceed.
|
|
|
|
|
Logged
|
I tested negative for patience.
|
|
|
|
|
|
